Archery Girl

Aiming methods
There are two main forms of aiming in archery: using a mechanical or fixed sight or barebow. Barebow aiming methods include Gap, Split Vision, Point of Aim, String Walking, Face Walking and Instinctive Aiming.
Mechanical sights can be affixed to the bow to aid in aiming. They can be as simple as a pin or optical with magnification. They usually also have a peep sight (rear sight) built into the string which aids in a consistent anchor point. Modern compound bows automatically limit the draw length which gives a consistent arrow velocity while traditional bows allow great variation in draw length. Mechanical methods to make a traditional bow's draw length consistent are sometimes used. Instinctive archers use a sight picture which includes the target, the bow, the hand, the arrow shaft and the arrow tip, as seen at the same time by the archer. With a fixed "anchor point" (where the string is brought to, or close to, the face), and a fully extended bow arm, successive shots taken with the sight picture in the same position will fall on the same point. This allows the archer to adjust aim with successive shots in order to achieve accuracy. A fixed anchor point cannot be used with short bows, which by definition do not allow a full draw. Modern archery equipment usually includes sights. Instinctive aiming is used by many archers who use traditional bows. The two most common forms of a non-mechanical release are split-finger and three-under. Split-finger aiming requires the archer to place the index finger above the nocked arrow, while the middle and ring fingers are both placed below. Three-under aiming places the index, middle, and ring fingers under the nocked arrow. This technique allows the archer to better look down the arrow since the back of the arrow is closer to the dominant eye, and is commonly called "gun barreling" (referring to common aiming techniques used with firearms).